1st Build First 3D Printed Armor! - HALO: INFINITE Mk VII


FLEX TAPE

Member
Like this
 

Attachments

  • 20210816_133206.jpg
    20210816_133206.jpg
    1.7 MB · Views: 63

JTF4

Member
Ok. It looks like you've made 1 or 2 cuts so far. Now, if you click the model, go to edit, and click separate shells, then you should be able to select the cut sections individually
 

FLEX TAPE

Member
Ok so it worked! But the top isn't filled in at the cut. The bottom is but when it's in cura it's broken because it isn't solid on the seam. How would I fill that in there?
 

Attachments

  • 20210817_131114.jpg
    20210817_131114.jpg
    2.5 MB · Views: 34

JTF4

Member
Ah! Forgot to tell you about another option‍♂️

when you plane slice, there’s an option for fill that defaults to no fill. You need to select remeshed fill to fill those cut points.
 

FLEX TAPE

Member
Ah! Forgot to tell you about another option‍♂️

when you plane slice, there’s an option for fill that defaults to no fill. You need to select remeshed fill to fill those cut points.
Its weird I did that and it filled the bottom but not the top
 

FLEX TAPE

Member
Ok so I printed the right forearm and the two handplates with the last of my filament and they turned out great! Only problem is my last 3 packages have been lost in shipping and I believe my ordered filament will have the same fate at this rate. Anyway, here are some photos
 

Attachments

  • 20210819_105129.jpg
    20210819_105129.jpg
    1.5 MB · Views: 38
  • 20210823_125718.jpg
    20210823_125718.jpg
    1.5 MB · Views: 40

Spiderboy196

Active Member
Ok so I printed the right forearm and the two handplates with the last of my filament and they turned out great! Only problem is my last 3 packages have been lost in shipping and I believe my ordered filament will have the same fate at this rate. Anyway, here are some photos
Looking really good. Another mk7 person build right here ^_^
 

Sgt Whupass

New Member
Power went out and my print failed :( only have one spool of filament left so I cant print another thigh until I get more so I will be printing the right forearm
I know I'm a little late to that post but you can always just eyeball where the print stopped and slice the file up to that point and print the rest. I had an issue where my printer would just decide it was done printing randomly so i had to get really good at eyeballing the layer. little superglue and some bondo and you're back in business.
 

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top