First Halo Cosplay - ODST 3D print

[SmartAsh3184]

Hello amazing 405th community I have recently started the sizing stages of building my very first Halo cosplay the ODST armor!! Being new to cosplay and sizing with Armorsmith, I was wondering if anyone had any tips or suggestions about what I have so far (photos below). Any help would be appreciated. The cad files are from made 3D printable by MoeSizzlac Thingiverse Halo 3 ODST - Rookie - Full Armor Set.

 

[Parzival]

In my limited scaling experience my thoughts are below :

-The thigh appears the be the along the whole length of the leg, I think this could be restriciting if you attempt to sit, maybe a little less length there?

-The shin dips below the ankle and could be well into the footwear at that point.

-The gauntlet appears to also be along the whole length of your lower arm. This could restrict when you go to bend your arm, put your own helmet on, etc. (Imaged attached showing my setup) I believe you would want to lower that length along the arm. My elbow piece was roughly in line with my elbow when bent. I used FromTheBrink files for my gauntlet shown.

-Chest / Torso items look good to me