First time/project and looking for some help!

Sparan135Wade

New Member
Hay Gang! Just wanted to start by saying that I am super excited to finally start down the path of making Halo armor! I've known about the 405th from a while now but things have come to light and I can really get going on it.
So first, I have acess to a larger 3D printer, a 11x11x13 inch base kind of printer. So I wanted to give it a test run with a helmet. Would love the halo 4 Anubis at the end of the day, but I am wondering if there are any 'Ready to print' wearable helmet files out there?

Thanks for the help squad.

W
 
 
This thread is more than 12 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top