Foam Halo 3 SRS-99D-S2AM Anti Material Rifle Build

[Shadowshail]

Been a hot minute since ive done a build thread but im finally at a place in life where i can knock something out with enough progress to begin a build thread so here we are!

Almost have half the body of the weapon finished up as well as about half of the muzzle suppressor (probably not what its called but meh) done as well.

Tomorrow i should be able to get the muzzle completely done as well as glue the first half of the body together and then also make the magazine. Next week would be the other half of the body, a 1/4 plywood middle support and then sanding stuff down to make it blend in.

 

[Shadowshail]

So i messed up and used the wrong thickness of foam for the weapon. All of the layers were cut using 10mm foam instead of 5mm foam. So i had to adjust by removing layer 4 and then changing layer 5 to a 5mm and then layer 6 to a 3mm foam. I also kept layer 1 as a single and not doubled up on it. Going to have to do the muzzle part all over again probably with 5mm foam as it was intended.

So far i have most of the main part cut and glued. Will be gluing it all up tomorrow and hopefully get some time to sand into it and give it some cleanliness to its look. Hell, im optomistic ebough to maybe have a couple coats of plastidip on it tomorrow!

Images are of layers 1-3 and 4 with magazine (without outside details)

 

[Shadowshail]

So finally got the main part glued up and about halfway to what i want sanded before i put a coat of plasti-dip on. Either way its good enough for the convention tomorrow as a display piece.

 

[N8TEBB]

Nice!

 

[Shadowshail]

Oof...More than 8 months old and no updates...Well wait no more!

I downloaded a bunch of reference images and realized the details for the rifle isn't accurate so I started adding details. Also changed jobs and got my office all setup for me to work on the costumes and such in my off time.

Here is the details and the starting of the upgrades and more progress pics!

1. Making the rifle barrel and the front little barrel thingy
2. Adding details on the magazine
3. Re-worked the handle under the barrel to a firm posterboard and added details
4. Re-worked the entire back end details.
5. Began foam putty and smoothing.