Halo Reach Rocket Launcher by The Apropalypse

I2aMpAnT · Oct 1, 2019

Well looks like I’m right back at it again! Starting to build The Apropalypse’s Halo Reach Rocket. This one will definitely be a time crunch since although it’s only 8 prints, They range from 5D8H to 2D and the last is only 14H.

This first piece was a 2D14H I believe.

Chooka · Oct 1, 2019

What % infil are you using? 2D+ is very long haha.

I2aMpAnT · Oct 1, 2019

Chooka said:
What % infil are you using? 2D+ is very long haha.

20% Infil/5 walls

TurboCharizard · Oct 2, 2019

Two days actually isn't bad with five walls. What size nozzle are your running? A standard 0.4?

I2aMpAnT · Oct 2, 2019

This was one of the smaller prints lol. I use the regular 0.4 nozzle and almost all stock print settings at 0.2 res.

I2aMpAnT · Oct 3, 2019

Got another piece finished and my stencils in!!! So far I have 2 pieces and need a lot of practice stenciling!

I2aMpAnT · Oct 5, 2019

Third print done, direct connection to the 2nd piece and let’s me start to put some pieces together to visualize. Turns out printing with 3 different printers actually isn’t lining up the holes 100% so I’ll have to do a bit of spade bit drilling. Got another Big piece finishing in a few hours and then it’s all smaller pieces left.

I2aMpAnT · Oct 6, 2019

Finally got another print piece done so the entire middle section Of the rocket is done. Really starting to look legit now!

Sean Anwalt · Oct 6, 2019

Dude this is looking legit! I think your stencil needs some TLC. But I'm so jealous of your weaponry right now.

I2aMpAnT · Oct 6, 2019

Sean Anwalt said:
Dude this is looking legit! I think your stencil needs some TLC. But I'm so jealous of your weaponry right now.

Oh the stencil was just a quick test, none of that paint is final. My only worry bow is that it’s pretty damn heavy. Should’ve went MUCH lower Infill.
But at least I’ll be able to keep quiet and not make so much noise...