Props How do you assemble Nerdforges armour?

Thread starter JDTV
Start date Today at 4:55 AM
Tags

3dprinted armor file issues haloreachcosplay mk5b

JDTV

New Member

Today at 4:55 AM

So im currently setting up my second armour set and instead of going with the same Halo Infinite Titlewavedesigns MK5B armour i decided to get Nerdforges MK5B set (The Halo Infinite MK5b has more curvature and a bit more smooth surfaces then the Halo Reach Armour....plus i am picky when it comes to getting the right armour) and some of it i dont get, the Chest pieces im trying to simply look and connect them together but i am struggling to see how to join them without them simply sliding off or not connecting fully and the Cod piece idk where to start with, it dosnt come as one full piece so i could easily scale it (i dont use armour smith) and it has these divets i dont understand, if the bits arnt there to help put together the cod piece then its just gonna break instanty

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.