Introduction And Wip

[Hyperdyne]

Hello,

Just wanted to share some of my work. I started on these in January and still need to do some more work on them.

I'm fascinated with the idea of making a suit that's easy to wear and doesn't limit mobility too much, so a lot of my efforts are going into the fitting of these pieces. I also really like Pepakura, since it is clean and neat, and it seems like a pretty easy way to develop physical versions of 3D models.

Thanks to everyone who supports the site. I have found a lot of helpful and useful information on here.

I used 80lb paper for the following models, and lasercut the cut and fold lines (saves a lot of time). Then used fiberglass and resin.

Also, the center of the three helmets is one that I modified as a 3D model and then set up in Pepakura.

Hyperdyne

 

[pooper]

Looking good there bud... whose pep file did you use for the helmets?

 

[masterchief85]

wooooowwwwwww

I want one! !!!!!!

they are very well. I expect to see advances of your work

 

[Hyperdyne]

Looking good there bud... whose pep file did you use for the helmets?

The green helmet pep file is by DANNIFOOD4LESS.

The center one was the same, before I took it into Maya and modified it.

The pep file for the helmet in the back is by FLYINGSQUIRL.

 

[ImaGonnaGetYou]

Amazing start. With that torso done, you've got about half of the pepping work out of the way.

The only thing I'd recommend is using a grey primer to make imperfections show more clearly, so the bondo stage is cut drastically in length.

Good luck, and I'm ready for some updates. This looks very promising.