Just another OSDT build thread.

[Mwares1]

The color looks good, even if it is a little glittery. It's probably more expensive but I'm primarily using Tamiya NATO black. Its a nice matt, slightly grayer black.

Thank you. The paint i wanted was the rustoleum soft iron but it is sold-out everywhere due to this paint shortage. Its hard finding something between grey and black right now.

 

[Rock Lobbster]

Fantastic job finishing the prints so far! I used Rustoleum slate on both my ODSTs and it gives a matte grey/blue/black look.

 

[Mwares1]

Fantastic job finishing the prints so far! I used Rustoleum slate on both my ODSTs and it gives a matte grey/blue/black look.

I was looking at that one but couldnt get a clear photo of it online.

 

[Mwares1]

The M7 is almost complete!!! Just 2 or 3 most parts to print out.

 

[Mwares1]

All parts printed now comes the fun sanding and gluing part. I use JB weld plastic. To me thats the best glue for PLA+.

 

[Mwares1]

Dont mind the set up like that. I had to prop up the suppressor because i glued it on while gluing the front and back of the main body together.

 

[Mwares1]

I have been killing it all week.

 

[Mwares1]

I have to take a break due to surgery but im back at it with the last parts guled on and putting down some filler primer.