MA37 ICWS

Status
Not open for further replies.

Rock Lobbster

RCO
405th Regiment Officer
Stream Team
Member DIN
S098
This is a little build log of my MA37 prop. I started by 3d printing a base and ended up having to rescale the mag to get it to fit properly
20181204_172203.jpg
After a copious amount of sanding, bondo, caulk, and other filler it was time to paint! I started by spraying it all black with $1 Walmart Spraypaint then spraying the entire thing gunmetal (via airbrush) and finally painting the proper pieces grey with an airbrush.
IMG_20181229_203549_472.jpg
WAAAYYY to much painters tape was required to actually mask this entire thing
IMG_20181229_211346_213.jpg
IMG_20181229_212439_037.jpg
A small yellow stripe was added towards the front to complete the in game look. Then it was a lot of smaller details and dremeled out a hole near the ammo counter and installed LEDs and a battery to make it light up!
20181231_144009.jpg
20181231_143714.jpg 20181231_143720.jpg 20181231_143746.jpg
It turned out BEAUTIFULLY and is by far my favorite prop I have done so far.
 
Great job Rock Lobbster......do you have any pic while you were in the middle of the build? Looks more like the only pics were during painting.
Only other picture I have from it was when it was 1/2 complete lol. The total print was separated into about 40 pieces which was a pain to put together.
20181127_162933.jpg
 
Status
Not open for further replies.
Back
Top