my helmet

[pacbury]

hi, i finished my pep helmet (well the pep bit anyway) and Im hopefully going to fiberglass tomorrow, but i just thought id let you all check it was right because i don't really want to waste resin. so heres the pics, oh and by the way i used the model shown in this tutorial here.
front view

close up of side

back

inside and neck

as you can probably see i had to cut ALOT of the neck away so it would fit, does this mean ill need to make supports for fiberglassing?
anyway all comments/critics welcome and i know the hot glue is messy im going to clean that before i fiberglass.
also while im here will a cold melt glue gun make life any easier when assembling pep because im wondering weather to buy one.
thanks, pacbury

 

[MC PwN 3R]

looks good so far...the neck piece that you cropped away will not affect the final overall look, in my opinion, as i did the very same thing.
next time, though, remember to align the numbers up correctly
like so
20 not 20
-- --
20 20

and for the most part, i dont really know about the cold melt glue gun...stick to the regular low temp glue gun and place small dots, not big chunky lines or else it will leak.