Necron overlord

Thread starter odst arobe
Start date Nov 20, 2025
Tags

3d printed cosplay armor eva foam leds

odst arobe

New Member

Nov 20, 2025

So being a fan of the GW warhammer when I came into Contact with the means of making an over lord scytheI had to do it, I new I wanted to it glow so I made the blade hollow, and once that was done I knew I had to make the full suit. Being a mix of print and foam. I’m happy with it as it’s been a very long time since I’ve done foam work and the first time I’ve ever done LEDS

Scythe is made from pvc pipe and printed parts
The mask is also printed everything else is foam

This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.