Need help with my helmet ugly problem.

[Spartan 2748]

I need help, I have been working on this helmet and it’s been getting worse and worse, it’s Airsoft proof and it’s made of a 3d print and then 3 fiberglass layers, I’m not going to try to take the fiber glass off so I tried using bondo filler, it works ok but it’s still a pain. Here is a video of how the whole helmet looks. I need suggestions on how to fix how ugly it looks. And too know if I did it wrong, did I use the wrong stuff to make it Airsoft proof? Could I just have used a special filament I’m not aware of? I’m I seriously being an idiot by using Fiberglass resin combo of all things to make it Airsoft proof? Please help me, I’m stressing out.

 

[BlazingForge]

Unfortunately we cannot help you since due to the rules of this community, Airsoft is a banned topic. So unfortunately we cannot help in this instance.

 

[Cadet]

The 405th and Paintball/Airsoft

New recruits: Please note that we do not discuss using our costumes for use while playing Paintball/Airsoft or in place or in addition to protective gear for any sport. Our costumes are purely for fun and for no protective purposes whatsoever and therefore we are not qualified to provide...

www.405th.com

Please note that we do not discuss using our costumes for use while playing Paintball/Airsoft or in place or in addition to protective gear for any sport. Our costumes are purely for fun and for no protective purposes whatsoever and therefore we are not qualified to provide advice on any of the following:

1. Making armor to wear during Paintball/Airsoft.
2. Making armor to wear over top of protective Paintball/Airsoft gear.
3. Altering Paintball/Airsoft gear by adding coloured film to visors which may in fact void your warranty.

You are more than welcome to share your build here, but any discussions with respect to that gear being used as protective gear or over top of protective gear for any purpose will not be allowed.

Thank you for your cooperation,

Division Staff