needler

[redragon74]

under the watchfull eye of my freind Old Timer from the 501st i started on my first prop hes only available when he can show up randomly after work. ive already got the Fiberglass done on it, and 1/3 coverd in Bondo. im going to put lights on it for the crystals *my lil surprise and ill post picks of it when done* heres my question... do i run the wires on the outside of it and then bondo over them? or should i dremel lil holes and run it inside of it?

 

[smick6]

I would run it throught the inside if it was me. If you ever need to replace a wire or bulb like you wont have to mess up the body of it. It would suck to go through all that hard work and have a light go out you cant change.

 

[redragon74]

point taken... i think i shall do that thanks man