I just printed out an entire helmet, 28 pages total, and I believe the scaling is spot on.
However, the printer is not printing the size designated in pepakura. I set the paper size to letter, which is the size of paper I'm using. Although, when I want to print it says "The size of paper specified by Pepakura Designer is not the same as printer setting. Adjust scale?"
If I hit no, then the pieces are falling off the pages and it's all screwed up. When I hit yes the pieces appear too small, and are not even in the same orientation (are rotated to landscape instead of portrait). When I cut out the two parts that make the hole where you put your head it is very small.
Help please! I don't want to keep wasting paper xD
However, the printer is not printing the size designated in pepakura. I set the paper size to letter, which is the size of paper I'm using. Although, when I want to print it says "The size of paper specified by Pepakura Designer is not the same as printer setting. Adjust scale?"
If I hit no, then the pieces are falling off the pages and it's all screwed up. When I hit yes the pieces appear too small, and are not even in the same orientation (are rotated to landscape instead of portrait). When I cut out the two parts that make the hole where you put your head it is very small.
Help please! I don't want to keep wasting paper xD