Where to start

Status
Not open for further replies.

kid

New Member
I have card board and something called card stock. I was wondering what to do. I have the program to print out the models and piece them together But I am a bit thrown off. How do I print out such a big helmet on just some small paper, what am i missing
 

Vexona

Well-Known Member
It sounds like you bought something smaller than 8.5 x 11 (letter sized)?

This is what people mean when they say cardstock: 110 lb. Cardstock

Also, when you go into Pepakura Designer, the default paper setup is A4. You should read through this thread and follow Frizzlefry's directions to adjust the printing and positioning options.

:devil:
-Vex
 
Status
Not open for further replies.
Top