Recent content by Dude12656

Dude that is so cool

Your doing an amazing job on the ODST build.

I'm almost done with the metal base of the helmet I'll be posting more pics of it later.

You did an amazing job on that armor. It looks so sweet.

Not really just halo type.

Here the pics of the helmet are. The visor isn't complete yet but it looks a hell of a lot better than it did. I also made the top more rounded.

Today I finished putting on the visor I must say its starting to look pretty sweet. Its really front heavy so I'm going to add a piece to the back to even it out.

I suck at drawing, so I'll be more descriptive. I am going to take make the visor and then run a more rounded piece from the tip of the visor to the back of the helmet. It'll be kinda like the MJOLNIR mark VI helmet.

Define fixed object. What if I put the the brim on and made a more rounded piece go from the front of the brim to the back o the hemet. Then I could round the side up more. Wow this helmet is going to be so heavy.

That whole armor setup looks so cool. I gotta agree with the last post that helmet is pretty tight.

This is me in the helmet. I really need some suggestions about the top part of it because it looks horrible in my opinion.

I'm using a blend between some lighter metal and heavier gauge sheet, but I don't have the exacts. Seriously though any suggestions on what I should do as far as making it better/cooler. I'm open to any opinions. I forgot to mention that this is my first armor build and I was going to use...

Doesn't body filler shrink and get crusty over time. What do think of that haybusa spike idea.

The plan was to make my own helmet and make a full ODST armor. I want to pretty much make my helmet look cool, and I don't care how much it will weigh. I was also thinking of making a single spike running from the front to a little past the back, kinda like the hayabusa. Thanks for the...

Resin is stronger and I kinda wanted it to be really strong