I've been waiting for info back from The Hunters Lair on how high the parts need to be or a close gues to the height so I can get around to unfolding the Predator armor.
I, as a noob, effed up my chest file lol. Apparantly i thought mountain lines were valley lines and I inverted the buckle paths on the sides of the armor....now I guess I get to start over. I suppose thats a lesson that needed to be learned...
I, as a noob, effed up my chest file lol. Apparantly i thought mountain lines were valley lines and I inverted the buckle paths on the sides of the armor....now I guess I get to start over. I suppose thats a lesson that needed to be learned...
I had to keep my pep viewer open while I was doing my back plate..... and still had to redo a section that was an valley...back to El Salvador for 8 weeks so will work on some of the smaller parts, I didnt scale to size as it was a test for a foam/paper combo. Good luck and show us some pics Nemesis
Well since I have'nt heard anything back from the Predator community on how high I should make the Predator armor then I'm going to scale it to what I think will work most of the pieces like the chest file are pretty equla to a spartan chest so I will probably use the same scale as the robogenesis chest file and put in a 6 foot scale to get a guesstimate on how high to scale the parts. Expect the Predator armor to be done by the end of the week. I guess it's like the old saying goes when all else fails do it yourself the best you can.