commanderwyro

New Member
7 months of 3d printing, sanding and painting and the chief build is finished. currently weathering it and getting some final things finished like padding. gotta say im so damn happy with how it turned out.
1602396198552.png

20201003_143641.jpg


20201003_144658.jpg
IMG_8612.jpg
20201003_144746.jpg
 

Attachments

  • 20200909_173315.jpg
    20200909_173315.jpg
    1.4 MB · Views: 66

FLEX TAPE

Jr Member
Hey! I have a question. I have recently gotten my hands on a 3d printer and want to print the same armor. I ran into a problem where my hand doesnt fit past the opening of the gauntlet and it already felt too big. how did you go about fixing that?
 

FLEX TAPE

Jr Member
Hey! I have a question. I have recently gotten my hands on a 3d printer and want to print the same armor. I ran into a problem where my hand doesnt fit past the opening of the gauntlet and it already felt too big. how did you go about fixing that?
Also, how and where did you find the gasket that lines the inside of the chest pieces by your arms?
 

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top