1st Build First Rakshasa Build

[Owstoon]

Hello!

I'm fairly new to the armor printing scene but I figured my first would be some kind of rakshasa--not a lot of armor to it, seems pretty straightforward.

I'm looking for feedback regarding the chest armor, which I've scaled down to 85% to appropriately fit me (I'm a bit of a skinny minny). While in pictures it looks like the armor barely reaches across the chest, I'm wondering if I shouldn't scale it up just a but more to look larger.

 

[Negativecacti]

The biceps look like they're proper side but yes the chest plate does seem rather small.
To me it looked like in game it covered most of the chest/ribcage area. So I went from center collar bones to bottom on my ribs and about 90% side to side to allow natural arm movements across the chest

 

[Chief118]

The biceps look like they're proper side but yes the chest plate does seem rather small.
To me I looked like in game it was covered most of the chest/ribcage area. So I went from center collar bones to bottom on my ribs and about 90% side to side to allow natural arm movements across the chest

View attachment 350382

looks good

 

[Owstoon]

It's been a minute since my last update, but here's what I've gotten done in the meantime. The thighs and calves are a big on the bigger side (naturally, cuz I can't scale to save my life), but some EVA foam inserts make them fit fine. Only thing now is to figure out the buckles and straps.