Help Needed. Pepakura won't show Edge Id's


xXDashIVXx

Sr Member
Hi,

Recently downloaded a pepakura file but anytime I print it doesn't print the Edge ID's even though it is selected on the program. Can anyone help with this?
Sorry about the laye reply. Looks like your post somehow slipped under the radar. If you didnt fix the issue, try making sure you didnt edit the line width so that the numbers aren't visible. To my understanding, if you enable fold angle it replaces the edge ID's too, so see of that was enabled
 
This thread is more than 5 months old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top