HeavyDutyART
New Member
So i'm done with peping my odst helmet and i have moved on to resining. Once i have completed that i'm planning on using bondo but i have one simple question. How does everyone carve detail into their helmets, after they bondo? do you etch in the lines with a fine tool while the bondo isn't fully dry? If your still not quite sure what i'm talking about look at this picture for a second.
http://www.bluerealmstudios.com/wp-content/gallery/legacyodst/odst11.jpg
if you look at the top of the helmet it is not just round. there are thin lines carved, that give it a much more detailed look instead of just a flat surface. Note: if there is already a thread that you know of explaining how to do this, please send me a link.
http://www.bluerealmstudios.com/wp-content/gallery/legacyodst/odst11.jpg
if you look at the top of the helmet it is not just round. there are thin lines carved, that give it a much more detailed look instead of just a flat surface. Note: if there is already a thread that you know of explaining how to do this, please send me a link.