ItsRaven's wonderful build thread (if i decide to actually work on it again)

I second the sharp-knife tip. You’d be surprised just how easy it is to get a clean cut with a fresh blade. If you don’t want to constantly change blades, you can always buy a blade sharpener. I sharpen the blade every 2-3 cuts and replace the blade after I complete each armour piece.
 
Nice, I'd recommend u change your knife blades though. A sharp blade can make an incredible difference to your foamwork, I use snap off blades as their cheap and you just snap the blade to get a sharper point.
Yeah it’s been a nightmare because I don’t have another blade that’ll work and this blade was already kinda dull to begin with lol
 
This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top