TurboCharizard
RXO and BCO
Canadian Regiment
405th Regiment Officer
Delta
Community Staff
Stream Team
- Member DIN
- S068
It's a very hard thing to explain since it's entirely vision and feel based. You can visually see when you've got a hardened and cured outer layer on the part using the EVAkura method but it's a very slight change in the sheen and lustre.Printed in ESUN PLA+! Just expressed very careful planning and care when sanding. if you are too rough while wet sanding it can actually put dents in the gloss coats or cut into it, since its not fully curing till later in the process technically