I havent been on in a while and very busy doing other things but anyways i have half of the jfo helmet 75% done I just need to know where can I get a decent filler to fill in the imperfections.
haaaaaaaaaaa much thanks..but ive seen on that someone rocked the hell out of it..even put in fans and a mock HUD and radar inside of the faceshield
that pretty much encouraged me to wanna make another one
Ok I have the cod peice 90 percent dont but the problem is that the croutch part is to small but the waist is really accurate. So should I just freehand that part?
This just a question but if I was to do a backtuck with my armor on would that work out? And on the neck seals I cant get my big head through the hole, so how do I resolve this issue.
OK! i know this could be either a dumb or smart decision but after thursday when I`m able to get a lot of foam floor mats I am going to redo the hunk of junk chest piece but after I finish the rest of my armor. Please reply.
OK! i know this could be either a dumb or smart decision but after thursday when I`m able to get a lot of foam floor mats I am going to redo the hunk of junk chest piece but after I finish the rest of my armor. Please reply.
Honestly, it is up to you. If you really dont like it then redo it. your chest piece looks good now i think so it is hard to say. Does it not fit well?? what exactly do you not like about it?
I just dont like how I did on the detailing anf the fact that I sprayed flex seal all over it so it is really bad damage then It has so many layers of paint but it fits well.