Odst helmet build

Clover arc

New Member
Made this helmet and parts for the 2024 Tampa bay comic con. It was fun. Paint job was... Okay.
Done the visor with the use of a plastic face shield. Applied a window tint onto it. Then cut the shapes out. Got led lights on the sides. with the source place on top. And boom.


 

Attachments

  • FB_VID_3813031836044345860.mp4
    1.6 MB
This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top