Reznoc
New Member
Hello everyone!
So I got this horrible idea to make a Halo pepakura armor and man is it time consuming?! Anyway I’ve taken my own measurements and most of my pieces get a little too big. Since I don’t own a printer that can print the heavier type of papers I contacted a local company to print them for me. This forced me to convert the .pdo- to .pdf-files using the CutePDF technique. The problem is that my .pdf-files have a border that is roughly 1cm thick. Now my question is, am I doing the right thing increasing the scale of the print by ~12% to receive the same measurements as in the Pepakura Designer 3 or is the converted .pdf correct?
I will start posting pictures once the pepakura is all done since it is such a boring and time consuming part.
So I got this horrible idea to make a Halo pepakura armor and man is it time consuming?! Anyway I’ve taken my own measurements and most of my pieces get a little too big. Since I don’t own a printer that can print the heavier type of papers I contacted a local company to print them for me. This forced me to convert the .pdo- to .pdf-files using the CutePDF technique. The problem is that my .pdf-files have a border that is roughly 1cm thick. Now my question is, am I doing the right thing increasing the scale of the print by ~12% to receive the same measurements as in the Pepakura Designer 3 or is the converted .pdf correct?
I will start posting pictures once the pepakura is all done since it is such a boring and time consuming part.