the reason I want clay is so that I can change it as I need and be able to carve in as much detail as I desire. best option I have until I can afford an expensive 3d printer and the knowledge to use it
make sure it is sulfer free if you are going to use it to make a mold. Most all of your various rubbers will not cure against anything containing sulfer
It's actually fairly trivial to -run- a 3D printer. There are quite a bit of files out there that just need sliced up in order to fit on a print bed, but would be OK as is. There are modelers that wouldn't agree, but that's what I think.
the reason I want clay is so that I can change it as I need and be able to carve in as much detail as I desire. best option I have until I can afford an expensive 3d printer and the knowledge to use it
It's actually fairly trivial to -run- a 3D printer. There are quite a bit of files out there that just need sliced up in order to fit on a print bed, but would be OK as is. There are modelers that wouldn't agree, but that's what I think.
I do like 3d prints however not knowing how to use one properly and not being able to afford one at the moment makes it difficult, one advantage with carving clay by hand is all the finishing and detailing are done
I highly recommend a sulfurfree plasticine instead of clay.
Clay is water based and will dry out and crack over time unless properly sealed. (I'm also assuming your talking about the kind of clay that come from the ground)
Plasticine is oil based so it not going to dry out, so you can leave it out for days with out worry,
I'm interested in what you are planing on sculpting
maybe able to give you a better staring point
thanks I will try and find this stuff, do you know any brand names for it? and I am going to sculpt out the teishen raikou helmet and a few other things
I buy almost all my stuff from "Sculpture Supply" (they also sell silicones for mold making as well as plastic for casting)
link to Plasticine http://www.sculpturesupply.com/list.php?offset=0&sf=category&vl=Modeling+Materials
they sell green or brown, I find the green is just a little harder. they sell 3 different hardness (soft, med, hard,) I recommend soft or med. (I mostly use med)
as for sculpting it I recommend buying or making a form to sculpt on top of even if its just a foam head, saves on material. then I would make a stand witch can be as simple as a stick of dowel shoved up the foam head and set in a bench clamp.