I have a dremel XPR 400 and I have a cutting disk. However, some areas especially in the Iron man helmet will make it nearly impossibly to use a cutting disk. Atleast in my opinion. I was wondering if anyone had any suggestions to making cuts in these areas.
Please excuse the condition of the helmet, I have not started to actually smooth the helmet yet. Pics are below
My main concerns are areas around the face plate especially in the front area. Also, the arched area above the ears. Was I suppose to cut this out prior to rondo during the resin phase? I kept it 1 piece until now to try and limit the possibility and amount of warping. Look forward to your responses. Thanks for the help.
Please excuse the condition of the helmet, I have not started to actually smooth the helmet yet. Pics are below
My main concerns are areas around the face plate especially in the front area. Also, the arched area above the ears. Was I suppose to cut this out prior to rondo during the resin phase? I kept it 1 piece until now to try and limit the possibility and amount of warping. Look forward to your responses. Thanks for the help.