I took apart the model and found a few problem areas and fixed them. the Helmet is showing fully printable no problems now. Take a look and let me know what you think.
Long story short, there were a bunch of polygons hanging out inside the helmet messing things up. Also, there were a few lines showing as a non-manifold edge (that screws it up too) even though the face looked good. Otherwise, I like it a-lot.
Long story short, there were a bunch of polygons hanging out inside the helmet messing things up. Also, there were a few lines showing as a non-manifold edge (that screws it up too) even though the face looked good. Otherwise, I like it a-lot.
Attachments
Last edited: