Help With ODST Pep.

Discussion in 'New Recruits' started by TillXValhalla, May 27, 2018.

  1. TillXValhalla

    TillXValhalla New Member

    Trophy Points:
    3
    This may be a Noob question and im sure its covered somewhere, Somewhere i have not been able to find despite searching but if i were to use the ODST Dutch pep file what would i have to do to the scaling? I only ask instead of trial and error as im trying to have this done by June 15th for Denver CC. I have the rest of the suit made minus the helmet. I had a go at a foam build for the helmet but i am less than pleased with it. Any help would be awesome
     
  2. Hein B107

    Hein B107 Jr Member

    Trophy Points:
    95
    Jup. All pep files still need scaling. What i did was print only the neck seal and test build it. If the head fits through it should fit.

    Note. Watch out for bobbleheadedness with scaling.
     
    TillXValhalla likes this.
  3. TillXValhalla

    TillXValhalla New Member

    Trophy Points:
    3
    Thanks for the heads up. I did a bit more research after mini freak out and I did a bit of algebra to get a ratio from a picture to me and went for it with the height just over 24 CM. Got to work realized I didn't have glue so just spent most of the night cutting the pieces out. Hoping to glue tonight .
     
    TurboCharizard likes this.

Share This Page