Edit: moved video to first page as well
"></param><embed src="http://www.youtube.com/v/
" type="application/x-shockwave-flash" width="630" height="350"></embed></object>
ok I found a few hours to get away from the babysitting this week, Im staying at my aunts house and watching her kids while there in europe, so I decided to work on another helmet from my pep library, another ironman. but after seeing dancing's model I may have to do that one as well, its seem there are a lot of models out there just doesnt seem like there hasnt been a perfect one as of yet, unless made out of clay. but here is my second version, along with some bondo tips.
I draw the lines were the detail needs to be, then I section off the areas with masking or duct tape.
Then I add my first layer of bondo and before it hardens i pul the tape
if the bondo goes over the lines like in the picture blow just use a razer knife
use the knife to cut it while its still soft and you will get those strait lines also if you cut off any bumps that it may have created cut those off as well its save you on the sand paper, also if its cold outside I will use a heat gun to help speed the hardening process because if you start to sand it while its still hardening you will waste a lot of sandpaper
after 3 hours of adding layers using the rasor knife and using 3 types of sandpaper
both my first version scatch build with no pep and then a pep version
ok I found a few hours to get away from the babysitting this week, Im staying at my aunts house and watching her kids while there in europe, so I decided to work on another helmet from my pep library, another ironman. but after seeing dancing's model I may have to do that one as well, its seem there are a lot of models out there just doesnt seem like there hasnt been a perfect one as of yet, unless made out of clay. but here is my second version, along with some bondo tips.
I draw the lines were the detail needs to be, then I section off the areas with masking or duct tape.
Then I add my first layer of bondo and before it hardens i pul the tape
if the bondo goes over the lines like in the picture blow just use a razer knife
use the knife to cut it while its still soft and you will get those strait lines also if you cut off any bumps that it may have created cut those off as well its save you on the sand paper, also if its cold outside I will use a heat gun to help speed the hardening process because if you start to sand it while its still hardening you will waste a lot of sandpaper
after 3 hours of adding layers using the rasor knife and using 3 types of sandpaper
both my first version scatch build with no pep and then a pep version
Last edited by a moderator: