My Cameo is acting up during the cut phase of working with my pepakura files. I have a feeling that the update to the software (to 3.3.437ss) is what is causing the problem. I have put in a support request with Silhouette directly, but thought I'd see if any of you were having difficulties too.
The issue I am having only occurs when I select the black (cut) lines to cut. When I send the cut settings to the Cameo and the cutting begins the blade starts the cut at the top left corner and cuts to each point in my project. The blade then cuts back and forth about 4 times, pulling up the paper and cutting right through my mat. I have tried to adjust the various cut settings and performed a number of test cuts, but the issue keeps on happening.
Are any of you having this issue?
The issue I am having only occurs when I select the black (cut) lines to cut. When I send the cut settings to the Cameo and the cutting begins the blade starts the cut at the top left corner and cuts to each point in my project. The blade then cuts back and forth about 4 times, pulling up the paper and cutting right through my mat. I have tried to adjust the various cut settings and performed a number of test cuts, but the issue keeps on happening.
Are any of you having this issue?