Preparing to start Helioskrill armor set

Depends on your printer. You are better of with a print bed size of 35x35 centimetres. I tried printing parts of it on my Ender 3 Pro and it was difficult. Haven`t really finished anything after the first failed attempt. Looking forward to how it turns out!
 
Ok. Mine is a CR10S with 300x300x400. Did you have any issues with sizing? That’s my biggest hurdle currently
 
Great tips for 3D printing:

Here area few different methods for scaling (most folks use armorsmith ever since 3D printing became a popular construction method):
 
This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top