last im not trying to do what aob called baby steps but im not to good with math or ant thing. so how did you get it the right size. or if you can just take the extra inch off the scale and post here.
last im not trying to do what aob called baby steps but im not to good with math or ant thing. so how did you get it the right size. or if you can just take the extra inch off the scale and post here.
Measure the length of your shoes in cm. Open up the boot file and look at the largest number in the lower right hand corner of the Pep Viewer or Designer. Change the scale until that largest number becomes equal to your measured shoe size.
Or you can use the boot tester made by Robogenisis.
Measure the length and width of the show, scale it up in pepakura by small increments, if the bottom right shows the length width and height similar to your shoe (but slightly larger) then your good to go.
I wear size 8 and a half men's size, my feet arent too big, but I know alot of people just wear shoes bigger than their feet for fashion, then again, sometimes, your feet are big and you need big shoes!
I wear size 8 and a half men's size, my feet arent too big, but I know alot of people just wear shoes bigger than their feet for fashion, then again, sometimes, your feet are big and you need big shoes!
Somebody I worked with (he got fired) wore size nineteen shoes! It wasn't for fashion either! He took his shoe off one time, and his foot was enormous! Imagine it, chief the clown...
lol i think i know a guy who weres size 24 lol well thx il measure my big ass shoe and do pep. iv never had this problem befor cuz i used cb but i have to make pep cuz cb dont match with plastic to much.
I'm 13 and I wear a size 10 1/2 mens, so when I want to get the boot scaled to my shoe size, It's always too tall, it comes up way above my ankle, any ideas to help me out?