Starting my armor tote!

[DragonFire]

I have decided to start work on an armor tote after seeing the guide and thinking "wow, that looks alot more productive and professional than trying to wheel it around an a cloth cart" so now here I am! I've already wiped it down with isopropyl alcohol and I'm ready to spray it with adhesion promoter! I wasn't sure if I sand it first or just spray it as it is. But! I plan to keep this tread updated with my progress as I go and look forward to pointers!

 

[xaero]

I was looking into getting one of the black totes with yellow lid from Costco, where did you pick this one up?

 

[DragonFire]

I was looking into getting one of the black totes with yellow lid from Costco, where did you pick this one up?

I got it from Walmart! It was $30 ish but it is exactly like the one from the guide! Minus it being clear on the sides, going to have to figure that out.

 

[Bargo]

I use a 190L Stanley and my Kit just fits in (without the Chest but with helmet)

 

[DragonFire]

Now it sprayed black! Just need to do the stencils and then the padding! I'll do a post about that update some time later!

 

[DragonFire]

I use a 190L Stanley and my Kit just fits in (without the Chest but with helmet)

I liked the idea of extra room and it's close to the original forum!

 

[DragonFire]

While I wait for the sencils to get done I went ahead and did the foam insides! The foam is not nessary but I feel more comfortable with it there. I got super close then ran out of hot glue on that last little bit which sucks. I do have a question though, after all the paint is on is there like a clear coat I need to apply?