Ill let you know when its done, the constant fiberglassing etc keeps making the inside smaller!!
As for the build, I did lots today. The dremel tool i posted a video about in the video section has really sped up work considerably.
I finished fiberglassing this morning and let it dry while I purchased the dremel, and then trimmed it up, and decided to add a little more fiberglass. Then I trimmed it up again so a good standard seen below:
I then used the dremel to clean out the drips of resin that hardened in the details areas where sand paper could not reach, and then I sanded the whole thing down ready for filler:
You can see how it looks much lighter when sanded:
Please note that I have not used primer so it wont look the same as most builds, ill probably use some on the last coat or so to get it perfect though.
I then began adding the filler ( first time ive created anything but I managed to mix it just fine)
Action shot!!
In the last two photos you'll see it in its current state. It is actually dry, but it looks darker when its not
Anyways, ill be working hard again tomorrow, and will probably have this section done, and possibly have made a good start on the bolt down lid section im about to create. I work well when i work fast though as it keeps my ideas flowing right onto the design board!