3D Printed Halo 5 Tactical Magnum

[blafftat]

I'm making a fully 3D printed Tactical Magnum from Halo 5. It'll be printed with clear filament, then spray painted and detailed. I'm printing all the pieces separate and then I'll superglue them together. This is also the 3rd small arms weapon I've done; I'll post them after this.

 

[blafftat]

Everything is printed out and ready to be sanded! It also fits well together.

 

[Wraith0912]

Lookin clean so far! I had forgotten the SOCOM pistol in H5 held up just as good as the one from ODST. Why use the clear filament, though? Is it all you had on hand? I haven't used clear filament myself, but I have a feeling based on that first picture that you might need a few coats to fully cover up that infill pattern.