That was just screwing around, just did a quick coat of base cause it was sitting on the work bench. That was by no means done and ready for paint like I say 10min for a couple coats of base. This was still just a raw cast with a coat of primer no work at all done on it besides a 5 min scuff.
Hope this works never tried vid before. Only have a few minutes before I'm gone for the day, but here's a prototype hing system for the faceplate. I had a system figured out but a fellow member( JUICE) posted his a bit ago and his was a little easier to built than mine so I used his. Works nicely this is just some plastic I cut out quick and mocked it together to try it out, the final hing should work smoother.
I'll post some details tomorrow morning as I'm off for the day/night. I'll only have my phone. cool Oh and thanks again Juice I would have never gotten around to actually drawing mine out.
You'll have to click the link can't figure out how to post it here, I suck.
As for the pivot points same as your diagram just some brass pins right now, I'll machine something up soon just wanted to make sure it works before putting in the extra work. I'll remake this after I get a solid design finished/tweaked, I want the jaw to move as well now so that'll be tomorrow sometime I hope. I'll post up some pics soon just have to remember it's just a quick mock up to see if it works nothing nice at all.
I kind of have it figured in my head (that's how I usually work no drawing plans) but if you feel like shooting me an email with what ya got I wouldn't say no.
Drgnfyre4, we can get ya hooked up just need to get past the next 3 weeks first. :eek :cool
Didn't get a chance to do the chin mod yet, but stuck a servo in there temp to see if it was going to work. Hope to play around with it a bit more in the next few days.