- Member DIN
- S386
Hello one and all . hacxor gave me a file a while back and it was a Carter helmet From REACH.
Its 3 layer thick PLA 0% infill. took 1.2 ish spools but I goofed and one part was 100% infill at some point !
I did managed to stop it really early on but just the mental math says
I know burned up loads on that goof. I am confident I can do one helmet on one spool . About 25 USD in plastic.
After I printed and put it together I used can foam to in some holes I made to stiffen up the helmet.
The visor is anti static bag. 10 bags for 9 bucks ..
If I have the time this next few months/Years , I wanna make all of NOBLE team's helmets. Just really for display.
Its 3 layer thick PLA 0% infill. took 1.2 ish spools but I goofed and one part was 100% infill at some point !
I did managed to stop it really early on but just the mental math says
I know burned up loads on that goof. I am confident I can do one helmet on one spool . About 25 USD in plastic.
After I printed and put it together I used can foam to in some holes I made to stiffen up the helmet.
The visor is anti static bag. 10 bags for 9 bucks ..
If I have the time this next few months/Years , I wanna make all of NOBLE team's helmets. Just really for display.
Last edited by a moderator: