Planned Halo Reach Jun build

Grinndo

New Member
Hello !

I am new on the forum as a poster, but I have been reading for a long time. Way back in 2009 I had a Master Chief armor:
288799_10150262758371795_3048153_o.jpg


I was planning to make myself an ODST, but after almost be done with the helmet, I decided to go for Jun from Halo Reach.
Here is the ODST helmet I have done Just need a visor and padding):
PXL_20231018_035820064.PORTRAIT.jpg


As for the Jun armor project, I only have the helmet printed, so it will be a winter project, I will take my time.
PXL_20231024_011341113.PORTRAIT.jpg


Have a good one everyone, and stay tune if this is something you are interested.
 
Looks pretty good. Are you gonna try to make a sniper to go with it?
I was going to but I just recently finish the game and at the end (2 missions I think) he use the M392 Designated Marksman Rifle, so just to have an easier time in convention, I will go with something a little smaller.
 
Oohh okay! Did you have any issues using the two different brands of paint? I know sometimes different spray paints react negatively to each other
Oh I know a lot about bad reaction with paint hahaha.

I did planned ahead on the masking. Each paint was directly on primmer. I didn't mix any paint over the other, especially when they are different brand.
 
Oh I know a lot about bad reaction with paint hahaha.

I did planned ahead on the masking. Each paint was directly on primmer. I didn't mix any paint over the other, especially when they are different brand.
Oh thats smart! you did it really well, its impressive! I never would have thought about that ngl
 
Added the second visor, a clear coat and the small lenses. Next is the details and weathering. Pretty happy with the result so far.
 

Attachments

  • PXL_20231110_053148843.PORTRAIT.jpg
    PXL_20231110_053148843.PORTRAIT.jpg
    134.7 KB · Views: 50
  • PXL_20231110_053204900.PORTRAIT.ORIGINAL.jpg
    PXL_20231110_053204900.PORTRAIT.ORIGINAL.jpg
    130.6 KB · Views: 65
  • PXL_20231110_053215678.PORTRAIT.jpg
    PXL_20231110_053215678.PORTRAIT.jpg
    94.6 KB · Views: 53
Oh the layered visor has such a COOL effect omg! I might have to try that when I get to my stage on my helmet... The paint looks really cool as well, I love how defined the colors are
 
This thread is more than 7 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top