I may give that a whirlI would actually suggest splitting the model to print the last little bit left, printing it out, gluing it on and blending it in with the rest. I haven't worked with Bondo but I've worked with other body fillers, and I think you'll have a hard time stacking enough of it up, then continiously refining its shape.
I'd second this. That much bondo would be liable to break or just fall off. I had the same issue with one of my thigh prints and printing out the remaining portion worked very well. If it ends up being too much you can literally remove a layer at a time to get what you need.I would actually suggest splitting the model to print the last little bit left, printing it out, gluing it on and blending it in with the rest. I haven't worked with Bondo but I've worked with other body fillers, and I think you'll have a hard time stacking enough of it up, then continiously refining its shape.
I've followed your guys suggestion and it came out perfect! Thanks again.I'd second this. That much bondo would be liable to break or just fall off. I had the same issue with one of my thigh prints and printing out the remaining portion worked very well. If it ends up being too much you can literally remove a layer at a time to get what you need.
Last parts I have to print are the shoulders. My first ones were child sizedI'm just gong to say this is way too big lol. I may reprint or just cut it down. More in the future once the thighsare done.
Keep those and compare with the torso, the Security shoulders are large in universe and based on the sizing of your bicep it looks pretty close.I'm just gong to say this is way too big lol. I may reprint or just cut it down. More in the future once the thighsare done.
I'll keep for now. I put on the chest and it did look good height wise, but width just looks massive.Keep those and compare with the torso, the Security shoulders are large in universe and based on the sizing of your bicep it looks pretty close.