Reach Spartan+SRS99AM Rifle Build

[EternalSentinel]

All good! Its not full undersuit. Its multiple pieces filling the empty space between armor parts so heat won't be as much of an issue.

Torso piece that sits inside the hard torso
Elbow sleeves and knee sleeves
Inner thighs
And then a lower abdomen front and back with crotch and butt

 

[Nimitz]

Makes sense, I'm doing similar things

just sewn

 

[EternalSentinel]

So not much of an update but yeh... all molds besides the torso (front/back/left/right) and ab/lower (front and back) are printed and can be cast from.


The ones that aren't done were partially printed but its only causing issues. Split them in Bambu.... used the peg system which lead to alot of alignment issues. Had to scrap them.

So now there's options...

Cast and Sell some of the necks, elbows, knees and shoulders...
Buy a bigger printer.
Reprint without the peg system which should help with alignment ironically.

But I have reached the point where I have wasted too much money on the project to stop but also to continue.