Lobbster's Reach Build

Rock Lobbster

RCO
405th Regiment Officer
Stream Team
Member DIN
S098
Current Suit Status:

LZI-pTQ61USS7x0ovKpwPF2Q=w590-h786-s-no?authuser=0.jpg


Start of Build Thread:


I decided to do a fun quarantine project with the 144 sq ft of harbor freight I happened to have sitting around so my custom spartan was born! Playing Reach on PC again really brought back the desire to be my own spartan.

Plans:
image (4).png
image (5).png


So far I have the shoulderpads, biceps, chest, and abwrap are complete! The chest was an absolute pain and probably took a week just by itself (the back sucks). I also decided to do a foam abwrap as an experiment and I think it might work out?
(Authors note: It did not work out)
20200504_230704.jpg
20200503_013713.jpg
20200503_013530.jpg
20200407_130049.jpg
20200403_225453.jpg
 
Last edited:
There weren't any unfolds for the Reach ammo pouch so I went ahead and modelled it for both 3d printing and foambuilding! The foam version is meant to be usable where the printed one does not have functionality. I'm giving the files out for free however please do not use these for commercial purposes. (aka don't sell prints or something like that).
unknown (1) (1).png
 

Attachments

  • Halo Reach Ammo Pouch.zip
    146.2 KB · Views: 393
Pouches have been made and attached to the chest using magnets! Shoulderpads are also properly mounted on the biceps (with magnets). I am now dreading the start of the forearms
20200522_004720.jpg
20200522_004638.jpg
20200522_000119.jpg
20200521_233003.jpg
 

Attachments

  • 20200521_161343.jpg
    20200521_161343.jpg
    1.1 MB · Views: 419
Last edited:
Progress time! Lots to report, JFO helmet (File from TurboCharizard) is complete with both attachments! I've also completed the thighs and soft pouch. It's a 200rd SAW magazine pouch that I'll eventually add more straps and the y buckle onto. Finally the forearms are complete, one being the tacpad (also from Turbo) and the other plain. I'm going to need to cut out a bit of the opening and add some elastic as my gloves make it a tight fit.
Thats all for now!
IMG_20200626_135234.jpg
20200627_220047.jpg
20200629_131228.jpg
 

Attachments

  • 20200627_220037.jpg
    20200627_220037.jpg
    983.9 KB · Views: 339
  • 20200622_214750.jpg
    20200622_214750.jpg
    1.8 MB · Views: 352
Last edited:
This thread is more than 6 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top